DALWORTH MACHINE PRODUCTS, INC
We recommend reconditioning your mill every year because there no better assurance that the next year will be hassle free than to have your most important component of facility in "like new" condition. We will dis-assemble and inspect your mill for wear. We will recondition all the components, resharpen your mill plates and replace the normal wear items like the bearing & seals. We will then reassemble your mill to the same standards as it was built by when it was brand new. Finally, after all quality control inspections are complete, we test run it for two hours to run it in and be absolutely certain it will be ready when you need it. We also advise you on your rate of wear or the effects of your products compared to the thousands of mill we have seen to allow you to determine a good preventative maintenance schedule for the future. Many time a simple adjustment in you plant procedures will minimize the effects to the mill adding years use to your most valuable component.
DALWORTH MACHINE PRODUCTS, INC RECONDITIONING SERVICES
At DALWORTH MACHINE PRODUCTS, INC, we specialize in restoring your Dalworth equipment back to O.E.M. standards. When you send your mills to us we make them like new again. Our staff members are professional, well trained and experienced.
DIY SERVICE ASSISTANCE - SERIAL NUMBER REQUIRED
We will be glad to assist you by phone or email if you decide to do your own maintenance. We still recommend you send your mill plates in to be resharpened from time to time. Normal turn around for sharpening is a week or less.
TECHNICAL ASSISTANCE - SERIAL NUMBER REQUIRED
We are always glad to provide current manuals and basic step by step procedural information for common situations as our customer need. Just email us your Dalworth Mill serial number and we can get the correct information to guide you through whatever you are dealing with.